Parkside PKZ 1000 A1 Traduction Des Instructions D'origine page 26

Adjusting the Brake (fig. 6 -7):
m Attention:
All settings and servicing at brake system let carried out only by trained
specialist personnel!
• Remove the housing cover by loosening the 3 screws on the back of the unit.
• To remove the safety splint, squeeze its ends (fig. 6/E).
• Fix the wheel for guiding the chain (fig. 7/D) by hand.
• Now turn the adjusting screw (fig. 6/C fig. 7) in the desired direction.
m Note:
The wheel for guiding the chain (fig. 7/D) must be able to rotate counter-
clockwise and clockwise. Do not tighten the adjusting screw (fig. 6/C) to
strongly.
• Rotating the wrench (fig. 7/K 19 mm) in a clockwise direction increases the braking
effect.
• Turn the wrench (fig. 7/K 19 mm) anti-clockwise to reduce the braking effect.
• Reinsert the safety splint and secure it by bending up the ends.
m Note:
If the braking effect is losing return the unit to a specialist workshop for
inspection. Let's check the thickness of the brake discs at regular intervals
by a specialist workshop.
Load chain
The chain life is sufficiently dimensioned. Nevertheless, the life is shortened due to external
influences. If a length of 21 chain links 400 mm is exceeded, the chain must necessarily
be replaced.
Length of 21 chain links
22 GB/IE