Metrological Verification; Guarantee - Chauvin Arnoux C.A 6549 Mode D'emploi

Remark : This fuse is in series with a 0.5 A / 3 kV internal fuse active only if there is a major fault in
the instrument. If the display unit still indicates GUARD FUSE after the fuse on the front panel is
changed, the instrument must be sent in for servicing (see § 8.2).
8.1.3. CLEANING
The instrument must be disconnected from any source of electricity.
Use a soft cloth moistened with soapy water. Rinse with a wet cloth and dry rapidly with a dry cloth or
forced air. Do not use alcohol, solvents, or hydrocarbons.
8.1.4. STORAGE
If the instrument is left unused for a long time (more than two months), it is best to carry out three
complete charging-discharging cycles before using it again.
The battery can be fully discharged:
- outside the instrument, at 3 A
or
- at the setting in which consumption is highest, i.e. 5000 V
8.2

METROLOGICAL VERIFICATION

As with all measuring or testing instruments, a periodic verification is necessary.
We recommend checking this instrument at least one a year. For verifications and calibrations, contact
our COFRAC-accredited metrology laboratories or the Manumesure agencies.
Information and coordinates on request:
Tél. : 02 31 64 51 43
8.2.1. REPAIR UNDER AND OUT OF WARRANTY
Send your instruments to one of the CHAUVIN-ARNOUX-approved MANUMESURE regional
agencies.
Information and coordinates on request:
Tél. : 02 31 64 51 43
8.2.2. REPAIR OUTSIDE MAINLAND FRANCE
For any repair work, whether under or out of warranty, return the instrument to your distributor.
Unless otherwise stated, our guarantee is valid for twelve months after the date on which the equipment
is made available (extract from our General Conditions of Sale, available on request).
Fax : 02 31 64 51 09
Fax : 02 31 64 51 09

9. GUARANTEE

92