Safety Instructions - IKRA ART 4030 Manuel D'utilisation

• Wear gloves and keep your hands warm.
• Make sure the device is well maintained. A tool with
loose components or with damaged or worn dampers
is prone to increased vibration.
• Always hold the handle firmly, but do not grip it con-
tinuously with excessive pressure. Take breaks often.
All of the precautions indicated above cannot exclude the
risk of Raynaud's syndrome or Carpal tunnel syndrome.
Therefore, it is advisable in case of long-term or regular
use to monitor the condition of your hands and fingers
closely. Seek medical attention immediately if any of the
above symptoms appear.

Safety instructions

Attention! Read all instructions contained herein.
Failure to observe the following instructions may
result in electric shock, burns and/or severe injury.
The term 'power tool' used in the following includes
both mains-operated tools (with mains supply) and
battery-operated tools (without mains supply).
KEEP THESE INSTRUCTIONS CAREFULLY!
1) Instructions regarding to safe handling
a) Wear goggles or properly fitted safety glasses, sturdy
closed shoes with non-slip soles, gloves, snug-fitting work
clothes and ear protectors (ear plugs or ear mufflers).
b) Minors should never be allowed to use an electric
trimmer. Never lend or rent your electric trimmer
without these operating instructions.
c) Do not use the trimmer if other persons, above all
children, or animals are near the working area.
d) Work calmly and stay alert. Operate the trimmer
under good visibility and daylight conditions only.
e) Before using the machine, the line and extension
cords have to be checked for signs of damage or
ageing. Do not use the trimmer when the cords are
damaged or worn.
f) Do not use damaged power supply cords, exten-
sion cords, couplings, plugs or cutting heads.
g) Careless use can cause injuries to hand and feet
by the rotating cutting elements. Do not switch on
the unit when hands or feet are near the cutting
elements.
h) Never use metal cutting devices.
i) Only use original spare parts.
j) Remove the battery before testing, cleaning or
working on the machine and when it is not in use;
k) Inspect cooling air slots on the motor housing at reg-
ular intervals for clog-ups and clean as necessary.
2) Maintenance
a) Children should be under supervision to ensure that
they do not play with the device.
b) Any other work should be performed by your dealer.
c) Never use metal cutting devices.
d) Clean the cutting head at regular intervals.
e) Check the condition of the cutting head at frequent
intervals. If the behaviour of the cutting head chang-
es (vibration, noise), check immediately as follows:
Switch off the trimmer, hold it firmly and bring the
cutting head to a standstill by pressing it against the
GB | Operating Instructions
3) General Instructions
4) Operational Precautions
10. Avoid to use the trimmer in poor weather condi-
11. Your electric trimmer is a high-speed, fast-cutting
12. Have your dealer or a specialist show you how to
GB-4
ground. Then disconnect plug from power supply.
Check condition of cutting head - look for cracks.
f) Have a damaged cutting head replaced imme-
diately - even if it only has superficial cracks. Never
attempt to repair a damaged cutting head.
g) Inspect cooling air slots on the motor housing at reg-
ular intervals for clog-ups and clean as necessary.
h) Clean plastic parts with a damp cloth. Do not use
aggressive cleaning chemicals.
i) Never hose down the electric trimmer!
j) Store trimmer indoors in a dry, high or locked place
and always keep out of reach of children.
1. Read the instructions manual
2. Have your dealer or a specialist show you how to
operate your trimmer.
3. Before using the machine check that your accu is in
good condition and that there is no damage. Never
use the trimmer with a damaged cutting head
4. Do not put the trimmer (lawn edge trimmer) into
operation if it is visibly damaged or worn.
5. Attention! Danger. The cutting head continues to
rotate after switch-off (flywheel effect). Keep your
fingers and feet well clear to avoid injury.
6. Before starting work check that your accu-trimmer
is in good condition and that it is operating prop-
erly. Pay special attention to the accu, switch and
cutting head.
7. Transporting the electric trimmer, e.g. carrying it to
another site: Switch of the unit, disconnect the plug.
1. Make sure the open side of the protection guard is
pointing away from yourself before you switch on
the trimmer.
2. Wear goggles or properly fitted safety glasses,
sturdy closed shoes with non-slip soles, gloves,
snug-fitting work clothes and ear protectors (ear
plugs or ear mufflers).
3. Always hold your trimmer firmly - make sure you al-
ways maintain a good balance and secure footing.
4. Use particular caution while working in dense
growth areas where your view of the ground is
obscured.
5. Never leave your trimmer outdoors in rain.
6. Do not cut wet grass or other growth. Never use
in rain.
7. Take special care in slippery conditions - on slopes
and uneven ground.
8. Work in a line across the slope and take special
care when turning around.
9. Watch for hidden obstacles such as tree stumps
and roots to avoid stumbling.
tions, especially if there is a risk of a thunderstorm.
power tool. The electrical connection and cutting
tool are potential sources of danger. Therefore,
special safety precautions must be observed to
reduce the risk of personal injury.
operate your trimmer.