Menu Settings; Rinsing; Setting The Language; Energy Saving - V-ZUG CCSXSL60 Mode D'emploi

refrigerator for longer than strictly necessary.
Clean the container each time you prepare milk as described in
Note 3 in the section "Making cappuccino".
All components are dishwasher safe, placing them in the top
basket of the dishwasher.
1. Turn the lid of the milk container clockwise then remove it.
2. Remove the milk spout and intake tube.
milk intake tube
3. Remove the froth regulator by pulling it outwards.
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. Make sure there are no milk resi-
dues left inside the holes and the groove on the fine end of
the froth regulator.
5. Check that the intake tube and spout are not clogged with
milk residues.
6. Replace the froth regulator, milk spout and intake tube.
7. Replace the milk container lid.
groove
froth regulator
hole

MENU SETTINgS

When you access the settings menu by pressing the P / ESC but-
ton (B7), the following menu items are available: Rinsing, Set
language, Energy Saving, Adjust time, Auto-start, Auto-off, Set
temperature, Water hardness, Statistics, Default values, Descale.
spout
hole

Rinsing

This function enables you to obtain hotter coffee.
Proceed as follows:
• When you turn the appliance on, if you want to make a
small cup of coffee (less than 60 cc), preheat the cup by
rinsing it with hot water.
• If on the other hand more than 2/3 minutes have passed
since the last coffee was made, before requesting another
coffee, you must preheat the infuser by first pressing the P
/ ESC button (B7) to enter the menu then the ▽ and △
buttons (B5 and B6) to select the "RINSING" function.
Press the OK button (B4). "RINSING PRESS OK" is displayed.
Press the OK button (B4) again.
Deliver the water into the underlying drip tray or alterna-
tively use this water to fill (and then empty) the cup to be
used for the coffee to preheat it.

Setting the language

To modify the language of the display, proceed as follows:
1. Press the P / ESC button (B7) to enter the settings menu.
2. Press the ▽ and △ buttons (B5 and B6) until "SET LAN-
GUAGE" is displayed;
3. Press the OK button (B4);
4. Press the ▽ and △ buttons (B5 and B6) until the required
language is displayed;
5. Press the OK button (B4) to confirm;
6. Press the P/ ESC button (B7) to exit the menu.
Alternatively, hold the P / ESC button (B7) down for 10 seconds.
The languages scroll through.
Hold the OK button (B4) down for 5 seconds to confirm. The ap-
pliance goes off.

Energy Saving

Use this function to enable or disable Energy Saving.
When enabled, the function reduces energy consumption in
compliance with European regulations.
To enable or disable the function, proceed as follows:
1. Press the P / ESC button (B7) to enter the settings menu.
2. Press the ▽ and △ buttons (B5 and B6) until "ENERGY
SAVING" is displayed;
3. Press the OK button (B4). "DISABLE?" is displayed (or "ENA-
BLE?" if the function has already been disabled).
4. Press the OK button (B4) to enable or disable the function
or the P / ESC button (B7) to exit the menu.
Please note: A few seconds may elapse between
"ENERGY SAVING ENABLED" mode and delivery of the first
drink; "PREPARATION UNDERWAY" is displayed.
17
EN