Delivering Hot Water; Changing The Quantity Of Hot Water; Making Cappuccino; Cappuccino - V-ZUG CCSXSL60 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
again.
NOTE 1: Never introduce pre-ground coffee when the machine is
off or it could spread through the inside of the appliance.
NOTE 2: Never add more than 1 measure, otherwise the applian-
ce will not make the coffee.
NOTE 3: Use the measure provided only.
NOTE 4: Introduce only pre-ground coffee for espresso coffee
machines into the funnel.
NOTE 5: If more than one measure of pre-ground coffee is used
and the funnel clogs, push the coffee down with a knife (fig. 21)
then remove and clean the infuser and machine as described in
the "Cleaning the infuser" chapter.

DELIVERINg HOT WATER

Make sure the water spout is in place (fig. 6).
Position a container under the spout.
Press the
(B6) button (fig. 20).
The message "HOT WATER" is displayed and hot water flows
out of the hot water spout into the container below.
You should not deliver hot water for more than 2 minutes at
a time.
To interrupt the flow, press the
The appliance stops delivery once the set quantity is rea-
ched.

CHANgINg THE QUANTITY OF HOT WATER

The appliance is set by default to automatically deliver 250 ml.
To modify these quantities, proceed as follows:
1. Position a container under the spout.
2. Press the
button (B6) again until "HOT WATER PRO-
GRAM QUANTITY" is displayed, then release the
ton.
3. When the hot water in the cup reaches the required level,
press the
button (B6) again.
The machine is now reprogrammed with the new quantity.

MAKINg CAPPUCCINO

Select the taste of the coffee you want to use to make the
cappuccino by pressing the
Remove the lid of the milk container.
Fill the container with about 100 grams of milk for each
cappuccino to be prepared (fig. 23). Never exceed the MAX
level (corresponding to about 750 ml) marked on the con-
tainer.
You should ideally use skimmed or semi-skimmed milk at
refrigerator temperature (about 5°C).
Make sure the intake tube is correctly inserted in the rubber
washer (fig. 24) then replace the milk container lid.
Position the froth regulator between the words cappuccino
button (B6).
but-
button (B2).
and caffelatte printed on the milk container lid.
The quantity of froth can be adjusted by moving the regula-
tor towards the word "caffelatte" for a denser froth.
Moving it towards the word "cappuccino" obtains a less
dense froth.
NO froth
"Denser" froth
Froth regulator
"Less dense" froth
Remove the hot water spout (fig 6) and attach the milk
container to the nozzle (fig. 25).
Position the milk tube as shown in fig. 26 and then place a
sufficiently large cup under the coffee and milk spouts.
Press the
button (B8). "CAPPUCCINO" is displayed
and after a few seconds, frothed milk flows out of the milk
spout into the cup below. (Delivery stops automatically).
The appliance delivers coffee.
The cappuccino is now ready. Sweeten to taste and, if desi-
red, sprinkle the froth with a little cocoa powder.
NOTE 1: While making cappuccino, the flow of frothed milk or
coffee can be interrupted by pressing the
NOTE 2: If the milk in the container finishes while delivering fro-
thed milk, remove the container and add milk.
Reattach and press the
again.
NOTE 3: To ensure the complete cleanliness and hygiene of the
milk frother, always clean the circuits in the milk container lid
after making cappuccino. "PRESS CLEAN" flashes on the display.
Place a recipient under the milk spout (fig. 26).
Press the CLEAN button on the lid (C3) and hold down for at
least 5 seconds (fig. 26) to start the cleaning function.
The appliance displays the message "CLEANING UNDER-
WAY" above a progress bar. You should not release the CLE-
AN button until the bar is complete indicating that cleaning
is concluded. When the CLEAN button is released, the fun-
ction stops. After cleaning, remove the milk container and
place in the refrigerator. The milk should not be left out of
the refrigerator for more than 15 minutes.
NOTE 4: To change the quantity of coffee or frothed milk the
appliance delivers automatically into the cup, proceed as descri-
bed in the section "Changing the quantity of milk and coffee for

cappuccino".

14
button (B8).
button (B8) to request a cappuccino

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ccssl674a75a76aSupremo slSupremo xsl ... Afficher tout

Table des Matières