V-ZUG CCSXSL60 Mode D'emploi page 11

16 x 2
x 16
x 16
x 16
Position the rails on the sides of the cabinet as shown in the
figure.
Fix with the screws provided, then extract them completely.
If the coffee machine is installed over a warmer drawer, use the
top surface of this as a reference to position the rails.
In this case, there will be no surface to rest the rails on.
x 1
x 1
Fix the power cable with the clip.
The power cable must be long enough to allow the appliance to
be extracted from the cabinet to fill the coffee bean container.
The appliance must be earthed in compliance with legislation.
Electrical connections must be performed by a qualified electri-
cian following the instructions.
x 2
x 2
x 2
x 1
x 1
x 4 x 8
x 4
x 4
Position the appliance on the rails, making sure the pins are
correctly inserted in the housings, then fix it with the screws
supplied.
If the height of the appliance requires adjusting, use the spacer
disks provided.
x 4
If necessary, correct alignment of the appliance by positioning
the spacers supplied under or at the sides of the support.
11
x 8
x 8
x 4 x 8
x 4
x 4
x 4
EN