Time Zone Setting; Temperature Unit Setting; Alarm Time Setting - TFA 60.2548.01 Mode D'emploi

TFA_No. 60.2548_Anleitung 09.07.2018 11:12 Uhr
MULTI-COLOR – Radio-controlled alarm clock with colour change display and outdoor temperature
• Confirm the setting with the T.SET button.
• The manually set time is overwritten once the DCF time signal is successfully received.
5.2.1 24- or 12-hour system setting
• In the setting mode you can choose between the 12 HR or 24 HR system.
• In the 12-HR system AM (before noon) or PM (after noon) appears on the display.

5.2.2 Time zone setting

• In the setting mode you can make the time zone correction (+2/-1).
• The time zone correction is needed for countries where the DCF signal can be received but the time zone is different from the DCF time (e.g.
+1=one hour plus).
5.2.3 Day-of-the week language
• You can set the day-of-the week language in setting mode: German (GE - default), French (FR), Italian (IT), Spanish (SP), Dutch (DU), Danish
(DA) and English (EN).

5.3 Temperature unit setting

• Press the DOWN button in normal mode to change between °C (Celsius) or °F (Fahrenheit) as temperature units.
28
Seite 15
MULTI-COLOR – Radio-controlled alarm clock with colour change display and outdoor temperature

5.4 Alarm time setting

• Press and hold the AL.SET button for three seconds to enter the setting mode.
• 6:00 (default) or the last adjusted alarm time appear on the display.
• Press the UP or DOWN button to adjust the hours.
• Confirm with the AL.SET button.
• Set the minutes in the same way.
• Confirm with the AL.SET button.
• To activate the alarm function slide the ALARM switch to ON.
• The alarm time with the activated alarm symbol appear on the display.
• When the adjusted alarm time is reached, the alarm rings.
• Press any button (except SNOOZE/LIGHT) and the alarm will stop.
• If the alarm is not stopped manually, the ascending alarm tone automatically turns off after two minutes and it will be reactivated at the same set
time on the following day.
• The alarm symbol remains on the display.
• When the alarm rings, press the SNOOZE/LIGHT button and the snooze function is activated.
• Once the snooze function is activated, the snooze symbol will be flashing on the display.
• The alarm will be interrupted for 5 minutes.
• To deactivate the alarm function slide the ALARM switch to OFF. The alarm symbol disappears.
29