Alarm Time Setting - TFA 60.2556 Mode D'emploi

TFA_No. 60.2556_Anleitung
Radio-controlled alarm clock
• During night-time, the atmospheric interference is usually
less severe and reception is possible in most cases. A sin-
gle daily reception is adequate to keep the accuracy devia-
tion under 1 second.
6. Operation
• The device will automatically quit the setting mode if no
button is pressed for 15 seconds.
• Press and hold the + or – button in setting mode for fast
mode.
6.1 Manual setting of the time zone and time
• Press and hold the TIME SET button in normal mode for
three seconds.
• The clock hands move to 12.00 o'clock (default = without
time zone correction). Press the + or – button to make the
time zone correction (+3/-3). The time zone correction is
needed for countries where the DCF signal can be received
but the time zone is different from the DCF time (e.g.
+1=one hour plus).
26
26.09.2019 9:57 Uhr Seite 14
Radio-controlled alarm clock
Hands to 9 10 11
Time zone -3 -2 -1
• Confirm the setting with the TIME SET button.
• The hour hand flashes. Press the + or – button to set the
hours.
• Confirm with the TIME SET button. Set minutes and sec-
onds in the same way.
• Confirm the setting with the TIME SET button.
• The manually set time is overwritten once the DCF time
signal is successfully received.

6.2 Alarm time setting

• Press the ALARM SET button in normal mode to enter the
alarm mode.
• 7:00 (default) or the last adjusted alarm time appear on the
display. The alarm time hand pulsates.
12 1 2 3
0 +1 +2 +3
27