ECOVACS DEEBOT OZMO T8+ Manuel D'instructions page 32

No. Malfunction
DEEBOT misses cleaning
8 spots to be cleaned, or repeats
cleaning the area cleaned.
DEEBOT is making too much
9
noise when cleaning.
DEEBOT is not able to connect
10
to the home Wi-Fi network.
32
EN
Possible Causes
The cleaning cycle is interfered by small
objects or barriers on the floor.
DEEBOT is working on slippery polished
floors.
DEEBOT is unable to reach certain areas
blocked by furniture or barriers.
The TrueMapping Distance Sensor is
blocked.
DEEBOT is tangled or blocked with debris.
Incorrect home Wi-Fi username or password
entered.
Incorrect App installed.
DEEBOT is not within range of your home
Wi-Fi signal.
Network setup started before DEEBOT was
ready.
DEEBOT does not support 5 GHz Wi-Fi.
Your smartphone's operating system needs
to be updated.
Solutions
Remove power cords and small objects from the floor
to ensure cleaning efficiency. DEEBOT will automatically
clean the area missed, please avoid moving DEEBOT
manually or block the path during the cleaning cycle.
Make sure the floor wax is dried before DEEBOT starts
cleaning.
Tidy up the area to be cleaned by putting furniture and
small objects in their proper place.
Remove the objects that are blocking the TrueMapping
Distance Sensor.
Clean DEEBOT as described in section 4 Maintenance
and restart. If the trouble persists, please contact
Customer Care.
Enter the correct home Wi-Fi username and password.
Please download and install ECOVACS HOME App.
Make sure DEEBOT is within range of your home Wi-Fi
signal.
Turn ON Power Switch. Press the RESET Button.
DEEBOT is ready for network setup when its Wi-Fi
Indicator light flashes slowly.
Make sure the robot has been connected with 2.4 GHz
Wi-Fi network.
Update your smartphone's operating system. The
ECOVACS App runs on iOS 9.0 and above, Android 4.0
and above.