ECOVACS DEEBOT OZMO T8+ Manuel D'instructions page 31

No. Malfunction
DEEBOT returns to the Auto-
4 Empty Station before it has
finished cleaning.
DEEBOT does not clean
5 automatically at the scheduled
time.
When OZMO Pro is working,
the volume is higher compared
6
to using the OZMO mopping
system.
DEEBOT is stuck when cleaning
7
with OZMO Pro installed.
Possible Causes
Working time varies according to floor
surface, room complexity and the Cleaning
Mode selected. When the battery gets low,
DEEBOT automatically switches to Recharge
Mode and returns to the Auto-Empty Station
to recharge itself.
DEEBOT is unable to reach certain areas
blocked by furniture or barriers.
The Auto-Empty Station is too distant from
the center of the house.
Time Scheduling function is cancelled.
DEEBOT is switched OFF.
The robot's battery is low.
This is normal as OZMO Pro provides electric
oscillating mopping up to 480 times per
minute.
DEEBOT may have difficulty climbing over
obstacles when using OZMO Pro.
Solutions
Turn on Continuous Cleaning function in ECOVACS
HOME App. DEEBOT will automatically resume the
uncompleted cleaning cycle when Continuous Cleaning
is enabled.
Tidy up the area to be cleaned by putting furniture and
small objects in their proper place.
Please place the Auto-Empty Station against the wall of a
central room of the house.
Program DEEBOT to clean at specific times using the
ECOVACS HOME App.
Switch ON DEEBOT.
Keep DEEBOT switched ON and connected to the Auto-
Empty Station to make sure it has a full battery to work at
any time.
This is normal.
Please assist DEEBOT if there is a problem.
31
EN