Zanussi ZRA733W Notice D'utilisation page 43

3. Turn the spacer to the right position.
4. Tighten again the screws.
4
Levelling
Accurate levelling prevents the vibration and
noise of the appliance during operation. To ad-
just the height of the appliance loosen or tight-
en the two adjustable front feet.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate corre-
spond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
www.zanussi.com
2
1
3
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door,
do these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the
compressor cannot touch the floor.
• Remove the plinth (1).
• Remove the cap (2) and position it on the
opposite side.
• Unscrew the hinge (3) and remove the door.
• Unscrew the lower pin and the washers (3)
• Position the pin and the washers (6) on the
opposite side (7).
• Unscrew the other hinge (5)
3
2
1
43