Troubleshooting Guide - Ryobi EMS-1830SC Manuel D'utilisation

GB
F D
MAINTENANCE
Infrequent Lubrication as Required
Apply automotive type oil directly on slide tubes. It will
■
be picked up and dispersed by built in felt wicks.
Apply a light oil or a pressurized light spray oil to the
■
arm pivot shaft (47).
Apply a light oil or a pressurized light spray oil to the
■
torsion spring (46) as shown.
Apply a light oil or a pressurized light spray oil to the
■
lower guard spacer (44), roller (45) and cover plate (3)
as shown.
MOTOR BELT TENSION (FIG. 26)
The motor belt tension was properly adjusted at the
factory. However, to check the belt tension:

TROUBLESHOOTING GUIDE

General
Problem
Blade hits table
Angle of cut not accurate
Can't move miter adjustment
Power head wobbles
Power head won't fully rise
or blade guard won't fully close
Blade binds, jams, burns wood
Rough cuts
Tool vibrates or shakes
Power head hard to
pull/push down
E I P NL
Probable Cause
1. Misalignment
1. Misalignment
1. Sawdust under table
1. Loose pivot points
1. Lubrication needed
2. Part failure
3. Pivot spring or guard spring
not replaced properly after service
4. Sawdust sticking to stops
1. Improper operation
2. Dull blade
3. Improper blade
4. Bent blade – check flatness
across expansion slots on blade
1. Sawblade not round
2. Sawblade damaged
3. Sawblade loose
4. Other
1. Lube needed
S DK N FIN
English
Use a Phillips screwdriver to remove the five screws
■
holding the belt cover and remove the cover.
To check the belt tension squeeze the belt. Using light
■
pressure the belt should deflect approximately
25.4 mm.
To adjust the tension:
■
- Use a Phillips screwdriver to loosen(but do not
remove) the six motormount screws.
- To increase the belt tension turn the adjusting
socket head set screw clockwise. To decrease the
tension turn the adjusting set screw counter-
clockwise.
Note: Excessive belt tension will cause the motor to
fail prematurely.
- Securely tighten the six motormount screws.
Replace the belt cover.
■
Suggested Corrective Action
1. Get authorized Service
1. See "Alignment" section
1. Vacuum or blow out dust
1. See Bevel Pivot Adjustment
1. See "Lubrication" section
2. Get authorized Service
3. Get authorized Service
4. Inspect/clean stops
1. See "Basic Saw Operation" section
2. Replace or sharpen blade
3. Replace with 305mm diameter blade
4. Replace blade
1. Replace blade
2. Replace blade
3. Tighten arbor screw
4. Get authorized Service
1. See - "Lubrication" section
28
GR H CZ RUS
Wear Eye Protection
in "Alignment" section
designed for the material being cut
RO PL