Laser Guide - Ryobi TS1143L Manuel D'utilisation

KNOW YOUR COMPOUND MITER SAW
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
7-1/4 in. BLADE
A 7-1/4 in. blade is included with the compound miter saw.
It will cut materials up to 1-1/2 in. thick or 4-1/4 in. wide,
depending upon the angle at which the cut is being made.
BEVEL LOCK KNOB
See Figure 2.
The bevel lock knob securely locks your compound miter
saw at desired bevel angles. A positive stop adjustment
screw has been provided on each side of the saw arm.
These adjustment screws are for making fine adjustments
at 0° and 45°.
BLADE WRENCH STORAGE
A blade wrench is packed with the saw. One end of the
wrench is a phillips screwdriver and the other end is a hex
key. Use the hex key end when installing or removing blade
and the phillips end when removing or loosening screws. A
storage area for the blade wrench is located in the saw's base.

LASER GUIDE

For more accurate cuts, a laser guide is included with your
miter saw. When used properly, the laser guide makes
accurate, precision cutting simple and easy.
LASER GUIDE SWITCH
See Figure 2.
Use the laser guide switch to turn the laser guide on and off.
MITER FENCE
The miter fence on the compound miter saw has been
provided to hold your workpiece securely against when
making all cuts.
MITER LOCK LEVER
See Figure 3.
The miter lock lever securely locks the saw at desired miter
angles. To adjust miter table, pull miter lock lever forward and
up to unlock table. Push lever back and down to lock table.
FEATURES
"D"
HANDLE
UNLOCK
SAW ARM LOCKED IN DOWN POSITION
TO
UNLOCK
MITER
LOCK LEVER
10 - English
LASER GUIDE
LOCK PIN
REAR BRACKET/
CARRYING HANDLE
TO
LOCK
SWITCH
BEVEL
LOCK KNOB
Fig. 2
Fig. 3