Unpacking; Correct Use; Useful Information - IKA VC 10 Mode D'emploi

Unpacking

• Please unpack the device carefully.
• In the case of any damage a detailed report must be sent
immediately (post, rail or forwarder)
Delivery scope
Vacuum controller IKA VC 10
®
Universal plug-in power
supply unit
USB A - micro B cable
Use
Together with the accessories recommended by IKA
VC 10 vacuum controller is suitable for the controlled evacuation
of air (gas) from laboratory devices and equipment (e.g. rotary
evaporator or laboratory reactors, and also for classical separation
or filtration or drying tasks in the laboratory) in conjunction with a
suitable vacuum source (e.g. IKA
ne vacuum pump).
Range of use (indoor use only)
- Laboratories - Schools
- Pharmacies - Universities
This instrument is suitable for use in all areas except:
• residential areas,
• areas that are connected directly to a low-voltage supply
network that also supplies residential areas,
• areas exposed to explosion hazards.
In addition to a high-resolution Al
VC 10 vacuum controller has an integrated vacuum valve and a
venting valve. As a result, the IKA
be used without any additional peripheral devices.
The device provides two basic modes of operation:
Two-position control and analogue speed control.
The change between the two modes is performed automatically
by plugging or unplugging the connector cable at the "MVP 10 di-
gital" interface. Depending on the selection made, some submenu
items may not be available (greyed out on the display).
Unpacking
Fig. 2
Fig. 3

Correct use

® , the IKA
MVP 10 basic/digital membra-
®

Useful information

O pressure sensor, the IKA
2 3
VC 10 vacuum controller can
®
Vacuum hose 1 m
Y connector
Operating instructions
Warranty card
The IKA ® MVP 10 digital membrane vacuum pump can be opera-
®
ted automatically with the IKA
Therefore, it can be used for automatic boiling point recognition,
programmed pressure-time curves or programs from the solvent
library, for example.
Mode of operation: Stand device
WARNING
® With two-position control, parameters from the solvent library can
be applied or target values specified in manual mode.
With analogue speed control, an automatic mode as well as the
setting of the percentage pump speed can also be preset.
Space requirement: To connect all peripheral devices you will need
approximately WxDxH 150 x 200 x 155 mm³ space for the device
with connected plugs.
Fig. 4
Fig. 5
VC vacuum controller.
®
The device must not be used for:
- vacuation of biological biotopes,
- evacuation of explosive, corro-
sive or gas volumes,
- throughput/use of fluids!
31