Intended Use; Unpacking; Factory Settings - IKA ETS-D5 Mode D'emploi

Intended use

Use
• The ETS-D5 is an instrument for the
precise control of temperature. The
sensor on this instrument must be
inserted at least 20 mm into the me-
dium to be tempered. The instrument
can be connected to any magnetic
stirrer or heating plate that has a con-
tact thermometer connection, provi-
ded this conforms with the require-
ments listed in the technical data (see
section Technical Data).
Area of use
• Indoor environments similar to that a laboratory of research,
teaching, trade or industry area.
• The safety of the user cannot be guaranteed:
- if the device is operated with accessories that are not supplied
or recommended by the manufacturer,
- if the device is operated improperly or contrary to the
manufacture's specifications,
- if the device or the printed circuit board are modified by third
parties.

Unpacking

Unpacking
• Unpack the device carefully. Any damage should immediately be
reported to the carrier (mail, rail or freight forwarding compa-
ny).
Scope of delivery
• IKA ETS-D5
• Operating instructions

Factory settings

The ETS-D5 is supplied with the following factory settings
• Operating mode: A
• Set-point temperature: - 10 °C
• HI-TEMP: 450 °C
Restoring parameter to favtory settings (RESET)
The following steps must be followed to restore factory settings:
• Switch off the equipment
• Press and hold down the membrane keys "" and "" and
switch on the equipment
• The factory settings will now be restored (see above)
13