IKA VC 10 Mode D'emploi page 43

Operating mode
Display
Programs
Operating mode A:
In this operating mode, the set target value is not saved when the
current run comes to an end or the device is switched off.
Operating mode B:
In this operating mode, the set target value is saved when the
current run comes to an end or the device is switched off, and the
value can be changed.
Operating mode C:
D
In this operating mode, the set target value is saved when the
current run comes to an end or the device is switched off, and the
value cannot be changed.
Operating mode D:
In this operating mode, the target value is applied if it does not
change after 3 seconds, or when the yellow background is dis-
played behind the target value. In operating modes A and B, the
target value is applied immediately when the target value is chan-
ged by turning the knob.
In operating mode C, the target value cannot be changed.
In the "Display" menu the user can specify what information will
be displayed on the main screen.
Select:
To select a program, use the rotating/pressing knob and press "Se-
lect". Only programs that have at least one program segment can
be selected.
When a program has been successfully selected, this is indica-
ted by a tick mark (). The vacuum controller is then in program
mode. In the main screen, the program view can then be selected
by turning the knob to the right. Turning the knob to the left re-
turns the user to the main screen.
Start:
To start a selected program, the push knob must be pressed in the
main screen.
Edit:
Edit the selected program parameters. Start to edit the selected
program parameters by pressing on menu option "Edit" with rota-
ting/pressing knob. The user can edit, delete or insert one selected
program segment in the program.
Delete:
Deletes the selected program. If a selected program is deleted by
pressing on menu option "Delete" with rotating/pressing knob, all
the program parameters will be emptied. The tick () disappears.
43