IKA VC 10 Mode D'emploi page 37

The following working screen appears automatically in the display.
Display of two-position control, e.g. with IKA
Hysteresis display for two-position control
Explanation of symbols on the working screen
The symbols displayed change depending on the status and set-
tings of the vacuum controller:
Lock key
This symbol means that the function of the key and of the
rotating/pressing knob for controlling the vacuum cont-
roller are disabled. The symbol no longer appears if the
functions are enabled once again by pressing the lock key
a second time (min. 1 sec.).
A
Operating mode
This symbol indicates the operating mode currently selec-
ted (A, B, C,D).
USB
This symbol means the vacuum controller is communi-
cating via a USB cable. The symbol no longer appears
if no USB cable is being used for communicating with
the station
Temperature sensor
This symbol appears when the temperature display is ac-
tive in the display.
MVP 10 basic. Display speed control: IKA
®
Timer
PC
PR
VP 10 digital to analogue connection
®
No hysteresis display for speed control
This symbol appears when the timer display is active
in the display.
PC control
This symbol means that the vacuum controller is con-
nected to a computer and the device is being controlled
from the computer.
Programm-Steuerung
This symbol means that the vacuum controller is con-
nected to a computer and the device is being controlled
from the selected program.
Continuous mode
This symbol indicates that the vacuum controller is in
continuous mode.
Vent
This symbol indicates that venting is enabled.
Vacuum
This symbol indicates that the current pressure is less
than the existing atmospheric pressure.
Detection
This symbol is displayed during the automatic boiling
point search, the system pressure is reduced further.
Boiling
This symbol indicates that a boiling point has been found
automatically, the system pressure is kept constant.
37