Replacing The Filter; Transport And Storage; Troubleshooting - Soehnle AIRFRESH WASH 500 Mode D'emploi

2. Lift the housing cover (1.1) from the device.
Pull the water tank up to remove it from the
housing (1.2).
3. Pull the tub out of the housing and remove
the cleaning drum (3.1).
4. Clean the tub and the cleaning drum with
warm water and a soft cloth.
5. Insert the cleaning drum back into the tub
and then push the tub into the housing.
Cleaning the housing
Clean the housing of Airfresh Wash 500 with
a slightly damp cloth.
Useful cleaning information:
Use a solution of 50:50 vinegar and water or
a 3:1 solution of vinegar essence and water.
Do not use abrasive or corrosive cleaners.

8. Replacing the filter

The combination filter should be replaced
after 1000 operating hours. "CL" will auto­
matically flash on the display after 1000 op­
erating hours. Use only original Soehnle fil­
ters!
Proceed as follows to change the filter:
1. Switch the device off and disconnect the
power plug.
2. Remove the filter cover on the side of the
device (2.1) and remove the filter (2.2).
3. Remove the packaging from the new filter
and place the new filter into the filter
cover (2.2). Ensure that the white side of
the filter faces in (towards the device).
4. Place the filter cover back into the device.
Ensure that the filter unit is correctly
inserted.
5. Reconnect the power cord to a power
outlet and switch the device on.
6. Push and hold key (M) for 5 seconds.
A signal sounds and the „CL" symbol
disappears. The operating time meter is
now reset.

9. Transport and storage

Transport
WARNING!
Always switch the device off before trans­
porting it. Always disconnect the power plug
from the power outlet. Transport the device
only when it is empty.
Storage
We recommend carefully cleaning your Air­
fresh Wash 500 before storing the device.
Ensure that all parts are clean and dry prior
to storing the device. Do not leave water in
the lower housing. Water that remains in the
Airfresh Wash 500 may result in mineral de­
posits and promotes the growth of unde­
sired micro­organisms. Store the Airfresh
Wash 500 in a cool and dry location.

10. Troubleshooting

Problem: The device does not work
• Ensure that the Airfresh Wash 500 is
connected to a power source.
• Ensure that water is in the water container
and that the container is inserted correctly.
Problem: Air humidity does not change
• Ensure that your room is not excessively
ventilated and close windows and doors.
• Ensure that the size of your room
corresponds to the recommended size of
this device.
Problem: Clicking noise during operation
• Ensure that the cleaning drum is inserted
correctly.
• Ensure that no hard water deposits are
located in the tub.
EN
11