Replacing The Filter; Transport And Storage - Soehnle AIRFRESH CLEAN 300 Mode D'emploi

Cleaning the housing
Clean the housing of Airfresh Clean 300 with
a slightly damp cloth.

9. Replacing the filter

The combination filter should be replaced
after approx. 4320 operating hours. The FIL-
TER RESET indicator flashes automatically
on the top of the device after approx. 4320
operating hours. Use only original Soehnle
filters!
Proceed as follows to change the filter:
1. Switch the device off and disconnect the
power plug.
2. Open the device as described above in
Chapter 7 and remove the combination
filter (1.4).
3. Insert the new combination filter into the
housing. Ensure that the new filter unit is
inserted correctly.
4. Close the device and fasten the screw
cap. Turn the device right side up and
place it on a solid surface.
5. Reconnect the power cord to a power
outlet and switch the device on.
6. Push and hold the ON/OFF switch (J) for
5 seconds. A signal sounds and the filter
reset indicator light disappears. The
operating time meter is now reset.

10. Transport and storage

Transport
WARNING!
Always switch the device off before trans-
porting it. Always disconnect the power plug
from the power outlet.
Storage
We recommend carefully cleaning your Air-
fresh Clean 300 before storing the device.
Ensure that all parts are clean and dry prior
to storing the device. Store the Airfresh
Clean 300 in a cool and dry location.
11. Troubleshooting
Switch the device off and disconnect the
power plug before performing the following
tests.
Problem: The device does not work
• Ensure that the Airfresh Clean 300 is con-
nected to a power source.
• Ensure that the filter is inserted correctly.
• Ensure that the bottom housing is inserted
correctly and close tightly with the screw
cap.
Problem: Insufficient airflow
• Ensure that the filter is clean. Please clean
the filter if it is soiled.
• Ensure that air inlet and air outlet are not
blocked or obstructed.
Problem: Excessive noise
• Ensure that no foreign objects are located
in the fan and remove them if necessary.
• Ensure that the filter is clean. Please clean
the filter if it is soiled.
• Ensure that the filter is inserted correctly.
• Ensure that the device is placed securely
and evenly on a solid surface.
EN
11