Daily Use And Operation; Cleaning And Care - Soehnle AIRFRESH WASH 500 Mode D'emploi

EN
11. Insert the filter unit back into the device.
Ensure that the filter unit is inserted
correctly.
12. Connect the power cord to a power
outlet.

6. Daily use and operation

Switching on and off
Push the ON/OFF switch (I) to switch
the Airfresh Wash 500 on or off.
When switched on, the display (H) will
show the current relative ambient air
humidity. (At first use the device starts
at medium humidification level).
Setting the operating time
Push the key (J) to set the desired
operating time. Select between 1 and
12 hours operating time or CO for
continuous operation of the device:
CO (standard) -01-02-03-04-05-06-
07-08-09-10-11-12
Changing the fan speed
Push the key (K) to select the fan
speed and thus the desired intensity
of humidity output:
Low – Medium – High
Setting the target humidity
Set the desired humidity in % by
pushing the key (L). The value will be
shown on the display while you set
the desired humidity. After a few sec­
onds, the display automatically
switches to the currently measured
value. We recommend a relative air
humidity between 40 % and 60 %.
The device can be set between 40 %
to 80 %. The device shuts off as soon
as the pre­set air humidity is exceed­
ed. The device does not shut off while
in continuous operation (CO).
10
Resetting the filter's operating
time meter
The combination filter should be
replaced after 1000 operating hours.
To reset the operating time meter,
push and hold key (M) for 5 seconds
until a signal sounds. Replacement of
the filter is described in Chapter 8.
Water tank is empty
A red symbol appears on the display
if there is no water in the tank and the
device shuts off automatically. Fill the
water tank as described in Chapter 5.

7. Cleaning and care

Cleaning the filter
Regular cleaning of the combination filter
(1x month) ensures faultless operation of the
Airfresh Wash 500.
1. Switch the device off prior to cleaning and
disconnect the power plug.
2. Remove the filter cover on the side of the
device (2.1).
3. Remove the filter from the cover (2.2)
Use the brush attachment of a vacuum
cleaner to thoroughly clean the filter. The
filter cannot be washed!
4. Insert the filter back into the filter cover
(2.2). Ensure that the black side of the
filter faces out. Insert the filter cover back
into the device. Ensure that the filter unit
is inserted correctly.
Cleaning of tub and cleaning drum
The regular cleaning of the tub and the
cleaning drum (every 2 weeks) ensures
the faultless, hygienic operation of Airfresh
Wash 500.
1. Switch the device off and disconnect the
power plug.