Using The Blender - Brandt ROB-304V Manuel D'instruction

Processing instructions when using the shredding and slicing disc
Food
Cabbage Remove the center and cut the cabbage into pieces
that will fit into the feeding-tube opening.
Carrots Peel and cut into 7 cm pieces
Onions Peel and cut in two
Potatoes Peel and cut into pieces that will fit into the
feeding-tube opening.
Hard cheese Cut into pieces that will fit into the feeding-tube
opening.
Cucumber Cut in two
C. Using the blender
- If you need to add extra ingredients remove the measure cup "k" from the jug lid "i". Your can use the
measure cup to measure and add liquids through the top hole on the jug lid, or just add ingredients
through the hole.
- Add ingredients to the blender jug gradually each time to ensure proper blending and to prevent overflow.
Never fill the juice with more than 600ml of any liquid and/or food. Make large portions of food in several
batches.
- Unless the recipe states differently, pour liquid ingredients into the blender jug before solid ingredients. The
liquid will help the process go faster.
- Calculate the blend speed period by seconds (5 to 30), not minutes, and always check the consistency of the
food. Continue blending until the desired consistency is reached. Over-blender will result in a loose
consistency.
- It is important to operate the blender with the jug lid in place.
- Do not remove the blender jug from the motor housing when the motor is running.
- With the measure cup removed, add solids gradually through the hole in the jug lid. Always cut solid foods
such as vegetables and cheese into small pieces before placing in the blender jug.
Cutting
16
Shredding
Peel and cut into pieces
that will
feeding-tube opening.
Assembly
- (PicC1) Place the blender jug "i' onto the
motor unit (a). Making sure the clamps are
locked into place.
- (PicC2) Fill the blender jug "i" with
ingredients, but never over the maximum
line (600ml).
- (PicC3,C4,C5) Place the jug lid "j" onto the
blender jug "i".
- (PicC6) Place the measuring cup "k" onto
the jug lid "j".
Operation
- (PicC7) Be sure the jug lid is securely in
place, plug in. Rotate the switch "aa" to "1"
position.
- (PicC8.C9) After using, switch off the
appliance and disconnect the plug from the
power outlet. And refer to "Cleaning &
Maintenance" section for cleaning. Remove
the blending "i" from motor unit. Don't
remove the jug lid "j", pour out the liquid in
the jug, the jug lid can separate the foam
from the liquid.
fit into the