Before Using For The First Time; Using Your Machine; Instructions For Use; Recommendations For Use - Brandt SOU-110V Manuel D'instructions

b) Before Using for the First Time
Wash the parts. Refer to Section 4 - Looking After and Cleaning Your Machine

3) USING YOUR MACHINE

a)

Instructions for Use

1. Vacuum packaging
1. To vacuum pack, place the items you wish to store inside the bag.
2. Clean and straighten the open end of the bag. Make sure there are no bends or wrinkles
on the end of the bag.
3. The bag must be as flat as possible near the welding bar and folds must be removed.
(Diagram 1)
4. Close the cover and press forcefully on each side (where the two lines are drawn). Press
until you hear two clicks. (Diagram 2)
5. Press "Vacuum+Seal". Firstly the air in the bag will be sucked out (Vacuum+Seal light)
and then the bag will be properly sealed (Seal light).
6. Once the bag is sealed press the machine's two locking buttons. (Diagram 3)
If you want to control the placing under vacuum yourself, you can stop it at any time by
pressing the STOP key.
2. Opening a sealed bag
Cut the end of the bag with a pair of scissors .
b) Recommendations for Use
1. Do not put too much in the bag. Leave enough length empty at the open end of the bag
so that it can be placed on the suction plate.
2. Do not wet the open end of the bag. Wet bags can be difficult to seal.
18