Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See Fig. A) - Parkside Performance PASSP 20-Li A2 Traduction Des Instructions D'origine

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
Safety guidelines for battery
chargers
This tool may be used by children
aged 8 years and above and by
persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the tool safely and are aware of the
potential risks. Do not allow children
to use the tool as a toy. Cleaning
and user maintenance tasks may
not be carried out by children
unless they are supervised.
To avoid potential risks, if the appli-
ance power cable is damaged, it
must be replaced by the manufac-
turer, its customer service or by a
qualified technician.
The charger is suitable
for indoor use only.
WARNING!
To avoid potential risks, if the appliance
power cable is damaged, it must be replaced
by the manufacturer, its customer service or
by a qualified technician.
ATTENTION!
This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3.
A current list of battery compatibility can be
found at www.Lidl.de/Akku.
PASSP 20-Li A2

Before use

Charging the battery pack
(see fig. A)
CAUTION!
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
Connect the battery pack
battery charger
Insert the mains plug into the mains power
socket. The green charge control LED
up briefly, then the red charge control LED
lights up.
The green control LED
charging process is complete and the battery
pack
is ready for use.
ATTENTION!
If the red control LED
that the battery pack
cannot be charged.
If the red and green control LEDs
flash, this means that the battery pack
defective.
Push the battery pack
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
to the high-speed
(see fig. A).
lights
indicates that the
flashes, this means
has overheated and
both
into the appliance.
GB │ IE
is
 7

Publicité

Table des Matières
loading

Table des Matières