Inserting/Removing The Battery Pack; Checking The Battery Charge Level; Fitting The Belt Clip; Switching On/Off - Parkside Performance PASSP 20-Li A2 Traduction Des Instructions D'origine

Inserting/removing the battery pack

Attaching the battery pack
♦ Push the rotation direction switch
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Fitting the belt clip

♦ Loosen the fixing screw
Phillips screwdriver (not supplied).
♦ Hold the corresponding hole of the belt clip
over that of the screw thread.
♦ Tighten the fixing screw
8
GB │ IE
■ │
into the
and remove the
to
as follows:
using a standard
3a
.
3a
Switching on/off
Turn on
♦ Press and hold the ON/OFF switch
start up the tool.
The LED work light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions.
Switching off
♦ Release the ON/OFF switch
the appliance.
Setting/preselecting the rotation
speed/tightening torque
♦ Press the torque selector
required torque in stages. The selected torque is
shown on the torque display
♦ Press the ON/OFF switch
speed and a low tightening torque. Increasing
the pressure increases the speed and the tight-
ening torque.
■ The tightening torque depends on the selected
speed/torque selection and impact duration.
NOTE
► When tightening wheel nuts, however, the
smallest torque setting must be selected to
avoid over-tightening.
► The integrated motor brake ensures that the
tool stops quickly.
ATTENTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!
to
lights up when the
is pressed lightly or fully.
to switch off
to select the
.
lightly for a low
PASSP 20-Li A2