Hendi 239506 Mode D'emploi page 5

After use
1. After using the pan, turn the thermostat knob to
"Off".
2. Then remove the plug from the power outlet
and remove the thermostat from the party pan.
Caution: The temperature sensor of the thermo-
stat will be very hot after the party pan has been
Precautionary measures when using the party pan
The party pan has a non-stick coating. Therefore
take note of the following:
• Do not use sharp metal objects (if you wish to cut
meat that has been cooked in the pan, first re-
move it from the pan and cut it on a board/plate).
• Do not use a knife to cut meat in the pan.
• Do not put the thermostat on the party pan, it
should never come in contact with the pan.
• Do not use detergent, or a nylon or metal brush.
They will damage the non-stick coating of the
pan.
General precautionary measures
The following precautionary measures must be
taken to prevent electricity failure, fire, or the pan
operating incorrectly.
If the lead overheats
Stop using the device and return it to the dealer/
supplier.
Correct 220V-240V power supply
The mains voltage must be 220V-240V, 1.4 kW (art.
239506 & 239483) or 1.6 kW (art.239605) from a
power outlet to which no other high-power device
is connected.
Handle the lead carefully
The lead should not be twisted. Do not remove the
plug from the power point by pulling the lead.
Do not submerge the party pan in water
Do not clean the party pan in water. After cleaning
the pan, allow it to dry before using it again.
used. Therefore, first allow the party pan to cool
down before removing the thermostat!
3. After allowing the pan to cool down, cover the ther-
mostat socket to prevent water entering it during
cleaning. Clean the party pan with a soft sponge.
Then wipe the device with a dry and soft cloth.
• The pan must be cleaned with a wet cloth after
use. Fat remaining on the surface can cause a
fire.
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects.
Do not use petrol or solvents! Clean with a damp
cloth and detergent if necessary. Do not use
abrasive materials.
The party pan must not be used in the following
situations:
On an unstable surface or near flammable sub-
stances (newspaper, paper, PVC tablecloths, floor
covering, etc.). The party pan must be positioned at
least 15 cm away from walls or furniture.
The thermostat
The thermostat is a fragile component, therefore
caution is required. Do not drop the thermostat, it
can break or cause a malfunction.
Always use the thermostat supplied, never use a
different one.
Ensure that you connect the thermostat in the ap-
propriate manner. When removing the thermostat,
never pull the lead but grip the plug itself to re-
move it.
If the thermostat is damaged or overheated, switch
it off immediately, do not continue to use it, but re-
turn it to the dealer/ supplier for repair.
To switch off or remove the thermostat, turn the
knob to "Off".
NL EN
5