Starting Up - Gram KPS 90 Mode D'emploi

Key descriptions:
T1: Temperature controlled chilling
T2: Storage
T3: Temperature controlled freezing
T4: Very cold storage
T5: Hard-soft chilling
T6: Defrosting
T7: Time controlled chilling/freezing
T8: Increase value
T9: Decrease value
T10: Start/stop cycle
LED indicators:
L1: Storage indicator
L2: Chilling/freezing followed by storage cycle
L3: Hard-soft chilling
L4: Defrosting
L5: Temperature display
L6: Time display
L7: Time count active
L8: Start/stop indication
DY1: Display 1 – shows temperature values
DY2: Display 2 – shows time values

Starting up

Press the main switch M1 .
Press T10 to start (L8 lights up).
The cabinet is now ready for programming and/or starting up. See sections on
programming the different cycles.
(At any new restart the last programming will reappear; in case of lack of power-
supply, when voltage recovers, the last programming will reappear, but an eventual
count of time will start from the beginning.)
NOTE:
Servicing
Make sure the appliance is switched off at the socket before service is performed on
electrical parts. It is not sufficient to switch off the cabinet by the ON/OFF key as
there will still be voltage to some electrical parts of the cabinet.
16
76-504-0926