Periodical Maintenance - EMAK DR 52 VBR6 Manuel D'utilisation

maintenance
l2 changing the forward and reverse gear-cables
take off the rear cover(see K1a)
l2a
l2c
M
changing the shoe
M1
changing a forward gear fitting
M1a
M2c
N

periodical maintenance

Engine : 1st oil change after 5 hours, then every 25
hours of use. Check with engine maintenance
manuel enclosed.
Tighten all the nuts on the machine after 5 hours of
use. Recheck periodically.
Forward-reverse friction lining : change when worn by
7 mm (original diameter : 125 mm, minimum diame-
ter after wear : 120 mm).
changing the blade brake shoe after 100 hours
use
(to be performed by an approved workshop)
l2b
l2d
take off the front and rear covers and the blade belt, and tip the engine up (see K1a a K1e)
M1b
M2d
New fitting
o
air filter / cleaning the motor
briGGs & strattoN
Do not use inflammable solvents to clean the foam insert in the air filter.
l3
adjusting the forward and reverse gear-cables and the
blade clutch-cable
l3a
slacken
the
locknuts
M2 changing a reverse gear fitting
M2a
New fitting
M2e
l3c
l3b
unscrew
the central
screw by
two or
three
turns
tighten the two locknuts
M2b
M2f
hoNDa
tighten
the two
locknuts
EN
7