Operation; Select Operating Mode; Preselecting The Rotation Speed; Switching On And Off - Parkside Performance PKHAP 20-Li A1 Traduction Des Instructions D'origine

Tool/chuck
♦ Grease the tool holder q slightly before
inserting the tool.
♦ Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.
Removing a tool
♦ Pull the locking collar w backwards and
remove the tool.

Operation

Select operating mode

WARNING!
► Do not press the function selector switch 1
until the appliance has come to a complete
standstill. Switching between functions while
the tool is still rotating can damage the appli-
ance.
Function selector switch
♦ Press and hold the release button
function selector switch 1. Turn the function
selector switch 1 so that the required symbol
engages at the arrow mark:
Function
Drilling
Hammer drilling
Chisel position adjustment
Chiselling
8
GB │ IE
■ │
Adjusting the chisel position
You can rotate the tool to the required position for
chiselling using this function.
♦ Turn the function selector switch 1 to the
position.
♦ Turn the tool in the tool holder q to the
required position.
♦ Turn the function selector switch 1 to the
position for the chiselling function.

Preselecting the rotation speed

You can use the rotation speed preselector dial 8
to preselect the rotation speed. Level 1 (low rota-
tion speed) up to level 6 (high rotation speed).
Work out the correct settings by carrying out a test:
– Level 3–6: high speed: for hammer drilling/
chiselling in concrete or stone
– Level 1–3: low speed: for drilling in steel or
wood
Switching on and off
on the
Switching the appliance on
♦ Press the ON/OFF switch 2.
Switching the appliance off
♦ Release the ON/OFF switch 2.
Symbol

Changing the direction of rotation

♦ Change the direction of rotation by pressing
the rotation direction switch 3 towards the left
or right.
PKHAP 20-Li A1