Only For Canadian Market - Faber LEVANTE G Instructions D'installation

ONLY FOR CANADIAN MARKET

For ducted installations only:
1
Remove the filters one at a time by pushing towards the back of the hood and
pulling down at the same time.
Remove the screws as pictured.
2
Remove two of the screws from the motor assembly housing as pictured.
Install the screws as pictured.
3
Install Grid
grid into the location shown in the picture below. (The correct location has a
rectangular cut out to accommodate the grid.)
Take care to screw the grid completely flush to avoid unwanted noise.
Phillips Screwdriver
D
with the two screws removed from step 2. Screw the protection
D
11