Hendi BLUE 205808 Mode D'emploi page 5

Special safety precautions
x Always remove the plug from the socket when filling or cleaning the deep fryer.
x The electrical installation must satisfy the applicable national and local regulations.
x To avoid the risk of fire, do not allow the oil level to drop below the minimum. Always use plenty of
oil in the bowl.
x Never use old oil as this increases the risk of fire.
x Never have the oil exceed the Max mark at the oil tank
Preparations before using for the first time
x Check to make sure the appliance is undamaged. In case of any damage, contact your supplier
immediately and do NOT use the appliance.
x Remove all the packing material and protection film (if applicable).
x Clean the appliance with luke-warm water and a soft cloth.
x Place the appliance on a level and steady surface, unless mentioned otherwise.
x Make sure there is enough clearance around the appliance for ventilation purposes.
x Position the appliance in such a way that the plug is accessible at all times.
Installation
x Stand the frame on its rubber feet
x For the deep fryer 4L (model 205808), install the handles to the housing by the screws included.
x Install the backing oil container in the frame.
x Install the element holder on the support.
NOTE! Ensure that the pin on the support enters the element holder.
Control Panel
Use
x Remove the plug from the socket.
x Fill the container with oil or hydrogenated oil until the MAX line.
Note! Solid fats must be preheated before filling, this avoids burnt fat and overloading.
x Plug the earthed plug into an earthed socket.
x Set the thermostat to the desired temperature. The orange lamp will light.
x When the set temperature is reached, the orange lamp goes out.
x You can now use the deep fryer.