Kratki PANTHER MERLOT Manuel D'utilisation Et D'installation page 58

Child Proof
Enabling:
To activate the Child Proof function press the
shows the icon.
Disabling:
To deactivate the Child Proof function press the
icon will disappear.
Manual mode
Lighting the fire in the stove with a single button (default setting)
• Press the button until you hear two short beeps. Starting the fi ing
sequence is confi med by the occurrence of a flashing i on on the display of
the burner. Release the button.
• Kindling the control flame is onfi med by a single signal.
• After kindling the main burner, the remote control
• automatically switches to the manual mode.
Lighting a fire in the stove with two buttons
• Simultaneously press the
short beeps. Starting the fi ing sequence is confi med by the occurrence of a
flashing i on on the display of the burner. Release the button.
• Kindling the control flame is onfi med by a single signal.
• After kindling the main burner, the remote control automatically switches to
the manual mode.
Information:
To change the kindling method, immediately after you install the batteries in the
remote control, hold the
a flashing di it corresponding to the current settings.
1 – Lighting a fi e by pressing
2 – Lighting a fi e by pressing the
End of the procedure of changing the method of lightening a fi e is confi med with the display
reading the appropriate number.
NOTE!!!
If, after several attempts to fire, ignition of the control flame does not take place, set the main
valve knob to „OFF" and refer to the section „Possible Problems and Solutions".
58
and
button and the
button for 10 seconds. The remote control display shows „ON" and
.
and the buttons.
buttons. The display
and buttons. The
button until you hear two