Kratki PANTHER MERLOT Manuel D'utilisation Et D'installation page 42

Rules
Install in accordance with local standards and regulations in force in the Member State or the region.
Connection to the chimney, wall and roof passages and all kinds of items used to install the stove
should be done in accordance with applicable standards of construction law.
Freestanding stove has been tested according to PN-EN-613 CIndependent gas-fi ed convection
heaters.
Location
Before connecting the device to a gas pipe and chimney, carefully choose the location of the device.
The stove should be positioned so that the combustion air installation had the minimum number of
bends. This will ensure appropriate chimney draft. It is also important that the fl xible wires connect-
ed to the gas stove were not exposed to excessive bending. Stove must be at least 60 mm away from
combustible building elements (Fig. 3-4). The temperature of the walls exposed to direct fi e cannot
be higher than 80°C. Under no ci rcumstances should you place the device in the hinterland of com-
bustible materials, such as wooden furniture, carpets and curtains. Due to the possibility of ignition,
it is prohibited to dry clothes, towels, etc. in the hinterland of the gas stove. Stove must be installed
on a stable non-flammable su face. The gas stove is equipped with special adjustable feet and two
adjustable mounting brackets allowing for attachment of the device to the wall. Never install the gas
stove on the back or the side wall. Installation is permitted only in the vertical direction.
Figure. 3. Location of the gas stove from the flammable housing omponents.
42