Kratki PANTHER MERLOT Manuel D'utilisation Et D'installation page 46

Passing individual wires through the casing of the gas stove, pay close attention to how they are
sealed. Sealing is achieved by means of special bushings and heat- resistant paper. Other elements
should be sealed with high-temperature silicone.
Figure 7. The way of routing out and sealing the capillary cable, the magneto wire, the tube of the
main burner and the tube of the control burner
DISASSEMBLY OF THE DEVICE
In order to gain access to the individual components of the automatic gas control system used in
the PANTHER MERLOT GAZ heater, first remove the top cover and then unscrew the side wall
screws. After loosening the screws, lift the side panels (Fig. 8). Then remove the bottom cover. The
bottom cover is fit ed with four M5 screws (Fig. 9).
In order to have access to the combustion chamber, main burner and control burner module, remove
the door by unscrewing the 8 M5 screws as shown in figu e 10. Next, remove the inner glass by loose-
ning the pressure strips (16 M5 bolts). Removal of the inspection is possible by unscrewing 6 screws
Figure. 8. Removal of the top plate and the side panels
46