Kratki PANTHER MERLOT Manuel D'utilisation Et D'installation page 56

NOTE!!!
The B6R-H9 remote control units have a built-in sensor used in the thermostat mode. The unit
continuously measures the ambient temperature and compares it with the temperature set on
the thermostat. It should be kept in a dark place, to rule out measurement errors associated
with direct sunlight.
NOTE!!!
Never use tools to change the position of knobs. Changing the position of the knobs can only
be made by hand, otherwise you may damage the controller. In the case of locking the knobs,
contact your service representative.
Gas Stove AB uses modern B6R-H9 remote controls set in accordance with the European standard
for radio frequency 868MHz. The remote control supplied with the stove requires a new code
transmission. To do it, in the first pla e, press and hold the „RESET" button on the receiver until you
hear two characteristic signals and then release the button. This operation should be done by means
of the thin element with blunt ends. Further on, from the remote control, press and hold
hear two short beeps, indicating the remote control is synchronized with the receiver. One long beep
indicates that the elements of the system have not been properly paired.
Figure 18. „RESET" button - receiver
INFORMATION
To view the current version of the software used by the remote control, simultaneously press the
and . Simultaneous pressing the
Deactivating the remote control.
Install batteries. All available icons will appear on the display and will flash. uring the flashin , press
the appropriate icon for the function and hold it for 10 seconds. The icon appropriate for the selected
button will flash u til the end of the deactivation process. The remote control display shows the
icon adequate for the selected function and two horizontal lines. If the function is deactivated two
horizontal lines will appear on the display when pressing the button responsible for its selection.
After replacing batteries, the settings will remain unchanged.
Activating the remote control.
Install batteries. All available icons will appear on the display and will flash. ress the appropriate icon
for the function and hold it for 10 seconds. The icon appropriate for the selected button will flash
until the end of the activation process. The remote control display shows the icon adequate for the
selected function.
NOTE!!!
If, when you try to light it, the control flame goes out, wait for at least five minutes before
trying again to light the stove.
56
button and the button will display the remote control model.
, until you