Plusmed pM-KN01 Mode D'emploi page 24

2. Connect the power, put the plug of power line connected with the power socket of the oxygen generator, and the
other end of the plug connects with indoor power socket, turn on the power switch. (See diagram 5)
3. Adjust well oxygen output flow according to the request, the red scale of the flow meter is MAXIMUM recommen-
ded oxygen absorbing flow (counterclockwise—on, clockwise—off, for common single treatment: pM-KN01 adjusted
to 5L/min; For double use: pM-KN01 adjusted to 3-5L/min.(see diagram 6)
4. Insert the intake end of absorbing oxygen tube onto the outlet of humidifier, then set the absorbing oxygen tube
over patient's ears, insert the nasal tube into patient's nostrils to absorb oxygen; the best absorbing time for health
care keeps 40-50 minutes per time, absorbing time for medical treatment shall be followed doctor's advice.
(see diagram 7)
5. After breathing oxygen, turn off the power, and pull up the nasal oxygen cannula from humidification bottle. If turn
off the machine without pull off the nasal oxygen cannula, it may cause oxygen tube bending and made remain water
in the humidification bottle backflow to machine, further lead to machine failure working .When discontinuous using,
please unplug the power plug.(see diagram 8)
24
Diagram 5
Diagram 6
Diagram 7
Red scale