Descaling; Faults And Possible Causes; Disposal - SOLIS OhEspresso 112 Mode D'emploi

Descaling instructions :
5.1 Turn machine on and heat up.
5.2 Add 2 Solis descaling tablets and ½ litre of
lukewarm water to the water tank.
Important: Please remove the water
filter BRITA from the water tank. Leave to
stand for approx. 15 minutes until the tablets
have dissolved completely.
5.3 Insert the descaling seal into the top oft he
coffee portion slot (Fig.7). The seal should
remain inserted in the machine throughout
the descaling and rinsing process.
Fig. 7
5.4 Place a container under the coffee outlet.
5.5 Briefly turn the coffee selector (4) to the
coffee position and turn the coffee selector
back to the position 0 when approx. 1 dl
water is in the container. Leave machine to
stand like this for approx. 10 minutes.
Important: The descaling solution must
flow from the «Coffee outlet» (7). Should
this not be the case, carefully re-position the
descaling seal (Fig. 7).
5.6 Repeat this procedure 3 times.
5.7 Rinse out water tank.
5.8 Fill water tank half full with cold water and
E
place in position.
5.9 Turn the coffee selector (4) to position I until
the water tank is empty.
If the pump stopps operating during the
rinsing cycle, turn the Coffee selector switch
(4) to position «0» and then again to position
«Coffee». The pump will restart.
5.10 Turn the coffee selector (4) back to position 0.
5.11 Pull descaling seal upwards and clean.
5.12 Replace the water filter BRITA in the water
tank, Fill the water tank with fresh water.
Machine is now ready to use again.
18
6. Faults and possible
causes
Please read the following points carefully before
sending in your appliance for repair. You will often
find you are able to resolve the problem yourself,
saving yourself trouble and inconvenience.
6.1 Coffee is not hot enough :
– Wait for the green operating temperature
indicator to come on.
– Cup ist too cold: Pre-heat.
6.2 No coffee comes out of the machine:
– No water in the tank
– The water tank is not properly inserted.
6.3 The appliance will not switch on:
– Appliance is not properly connected to power
supply/check fuse.
– Brewing unit cover is not shut properly.
6.4 Water pump makes a loud noise:
– Not enough water in the tank
6.5 The pod is not ejected:
– Clean the brewing unit shown on point 4,
«Care and cleaning»
– Check that the coffee waste container is
empty
If you cannot resolve the problem after checking
these points please return the appliance in its
original packaging, with details of the defect, to our
Customer Service Unit or approved Service Center.
7. Disposal of appliance
EU 2002/96/EC

Disposal:

In conformity with Directive 2002/96/EC
on waste electrical and electronic equipment
(WEEE), at the end of its life the unit should be
taken to an electrical appliance collection point for
its environmentally friendly disposal.