Becker Centronic VarioControl VC420-II Notice De Montage Et D'utilisation page 42

Deleting intermediate position II (tilt position)
Move the blind to intermediate position II.
First press and hold the STOP button and, within the next 3 seconds, press
and hold the UP button. Keep both buttons depressed until
▻ the receiver confirms.
► Intermediate position II is now deleted.
Intermediate position I
Intermediate position I is any shading solution position of
your choosing, situated between the upper and lower limit
positions. Both limit positions must be set before intermedi-
ate position I is set.
Intermediate position I is approached from the upper limit
position.
Programming intermediate position I
Move the blind from the upper limit position to the desired intermediate posi-
tion I.
First press and hold the STOP button and, within the next 3 seconds, press
and hold the DOWN button. Keep both buttons depressed until
▻ the receiver confirms.
► Intermediate position I is now saved.
Checking intermediate position I
Press the DOWN button twice within one second.
► The blind moves to intermediate position I.
42 - en