Wiring - Becker Centronic VarioControl VC420-II Notice De Montage Et D'utilisation

Caution
•
Risk of injury due to electric shock.
•
Connection may only be performed by a qualified electri-
cian!
• The device only offers back-of-hand protection, not
touch protection.
• Do not bend, shorten or lengthen the antenna.
•
Only operate the programming button with an insulated
tool.
•
If more than one drive is going to be operated by the radio
receiver, the drives must be decoupled by relay controls.
There is no need for decoupling in the case of our drives
with electronic limit switching.
• Always take into account the device switching current.
1. Connect the device as follows:
2. Program a transmitter into the receiver (see chapter "Programming the
transmitter")
3. Fasten the device in the socket.
32 - en

Wiring