How To Connect To A Plc - HBM MP60DP Manuel D'emploi

PME−MP60DP
2

How to connect to a PLC

The steps in successfully connecting to the Profibus:
1. Physically connect the device to the Profibus (see page 8 and page 9)
2. Configure the device parameters, see page 12 (can also be carried out
using HBM's "PME-Assitent" software).
3. Configure the Profibus message and set up its parameters with the aid of a
configuration tool (such as Step7) and GSE files, or manually as shown in
chapter 6.2.
A GSE file describes the properties of a Profibus node in standardized form.
The configuration tool uses it to define which data held on individual bus
nodes will be exchanged on the Profibus.
A default GSE file for PME modules is supplied with the device (on system
CD: hbmxxx.gsd = German version; hbmxxxgse = English version).
PLC
Fig. 2.1: Configuration with the aid of GSE files
A0623-6.1 en/de/fr
System configuration
GSE
Electronic device data sheets (GSE files)
PROFIBUS−DP
Profibus
configurator
5
HBM