Package Contents; System Requirements - Lindy 32397 Manuel Utilisateur

User Manual
Features
Provides a convenient and secure method of remotely locating workstations or
servers without compromising convenience and control
Distances of up to 150m supported between local and remote units
Dual console operation – control your computer / KVM Switch from both local and
remote locations
Remote Receiver unit features a built-in KVM Switch – allowing control of a local PC
High-resolution video support:
Adjustable VGA Tuning control to improve video quality
Easy, user-friendly installation – no software required
Supports PS/2 keyboard/mouse and VGA monitor signals
Compatible with all major operating systems

Package Contents

Local Transmitter unit
Remote Receiver unit
9V DC, 500mA Power Adapter (for the Remote Receiver unit)
1 x 3-in-1 KVM cable
This manual

System Requirements

VGA, SVGA or Multisync monitor for each console. The monitor should be capable
of supporting the highest resolution you will be using on any computer in the
installation
PS/2 keyboard and mouse for each console
Note: If you experience problems with mouse functionality, try using the same brand and
model of mouse on both local and remote units.
Additional Cable Requirements
If you want to connect a workstation to the remote receiver you require a 3-in-1 KVM cable (not
included). For optimum signal integrity and to simplify the layout, we strongly recommend that
you use high quality LINDY 3-in-1 KVM cables. The following lengths are available:
For connecting the local and remote units, Category 5 UTP, STP, FTP or PIMF cable is the
minimum requirement. Using lower quality cable will result in a degraded video signal.
See www.lindy.com
1m
2m
3m
5m
for our extensive range of CAT5 and higher cable.
1280 x 1024 @ 100m
800 x 600 @ 150m
No. 33711
No. 33712
No. 33713
No. 33714
2
English