Lubrication - LGB ABe 4/4 33 Série Instructions De Service

Lighting
This model features directional lighting:
Three white front lights and one white
rear light. Transparent red stickers are
included with the model to obtain a
prototypical red rear light when running
without a train.
The model has a "flat" multi-purpose
socket, with a removable cover, on
each end wall (Fig. 3). These sockets
can be used to provide track power to
LGB cars with lighting or sound
electronics.
To remove the cover of a socket, pull it
straight out. If the cover is tight, gently
use a small straight screwdriver to pry
it out. (Do not pull out the rectangular
outer housing.)
Power Supply
Attention! For safety and reliability,
operate this model with LGB power
supplies (transformers, power packs
and controls) only. The use of non-LGB
power supplies will void your warranty.
Use this model with LGB power sup-
plies with an output of more than 1
amp. For more information on LGB
power supplies for indoor, outdoor and
multi-train operation, see the LGB catalog.
Catenary Power Operation
This locomotive can be operated with a
powered catenary
Operating Modes). The bottom of this
model is marked with a red dot. Place
the model on the track with the red dot
pointing to the rail that is not connect-
ed to the catenary power supply (Fig. 4).
Hint: To operate multiple trains on the
same track, we recommend the LGB
Multi-Train System (see Multi-Train
System). With the Multi-Train System,
you can use an unpowered catenary
system for prototypical appearance.
CAUTION! This model may be powered
with a catenary on analog layouts
only. For operation with the digital
Multi-Train System, the model must
8
system (see
use track power. Otherwise, danger-
ously high voltages may result.
Attention! After extended operation,
this model may leave carbon dust or
other debris around the track. This dust
and debris can stain carpet and other
materials. Consider this when setting
up your layout. LGB are not liable for
any damages.
SERVICE
Do-It-Yourself Service Levels
Level - Beginner
Level - Intermediate
Level - Advanced
Attention! Improper service will void
your warranty. For quality service, con-
tact your authorized retailer or an LGB
factory service station (see Authorized
Service).
Hint: Additional expert instructions for
many LGB products are available at
www.lgb.com.

Lubrication

The axle bearings should be lubricated
occasionally with a small amount of
LGB Maintenance Oil (50019).
Cleaning
This model can be cleaned externally
using a mild detergent and gentle
stream of water. Do not immerse this
model.
Replacing the light bulbs
Lower lights 1: Remove the ring
around the lantern lens. Carefully pry
the lens away from the lantern. Using
tweezers, remove and replace the bulb.
Reassemble.
Upper lights 1: Pull the lantern housing
away from the model. Remove and
replace the bulb. Reassemble.