Preparation - SOLIS PRO Mode D'emploi Et Recettes

Assembling the Solis Blender.

Preparation

Before using the blender for the first time and after a
prolonged period of storage, you should clean the
mixing jug in warm water with some washing up
detergent and then dry it thoroughly.
1. Place the blender base on a dry, firm, and level
worktop. Check that the On/Off switch on the
blender base is set to "0" (middle position; OFF).
2. Position the assembled mixing jug on the holder of
the blender base. The dark slots in the base of the
jug must slide between the three oval guides on
the blender base. (See Fig. 1+2)
3. Then turn the mixing jug clockwise without using
force to the stop (about
the mixing jug onto the blender base. (See Fig. 3)
Important note: the motor only runs when the
mixing jug is correctly assembled and is locked onto
the holder of the blender base. If the motor does not
run, please check that the mixing jug is correctly
locked. The appliance is now ready for use and you
can place the ingredients in the mixing jug.
4. Now plug the power cord into a suitable 230V,
50Hz wall socket.
/ of a turn). This locks
1
4
fig 1
LOCK UNLOCK
fig 2
fig 3
37