Assembly - Makita EB5300TH Instructions D'emploi

ASSEMBLY

CAUTION:
Before performing any work on
the blower, always stop the engine and pull the
spark plug cap off the spark plug.
CAUTION:
Start the blower only after having
assembled it completely.
CAUTION:
Always wear protective gloves.
Assembling blower pipes
1. Insert the swivel pipe into the flexible pipe and
tighten them with the hose band.
2
► 1. Swivel pipe 2. Flexible pipe 3. Hose band
2.
Loosen and remove the clamp screw.
► 1. Clamp screw
For tube throttle model, be careful not to twist the cable
on the control handle when attaching to the swivel pipe.
3. Install the control handle / handle assembly onto
the swivel pipe and tighten them with the clamp screw.
3
1
1
► 1. Control handle / handle assembly 2. Clamp screw
4. Attach the flexible pipe to the elbow
For tube throttle model: Insert the elbow to the flexible
pipe. Attach the cable holder between the hose band
and the flexible pipe. Tighten the cable holder, flexible
pipe and elbow with the hose band. Set the control
cable onto the cable holder, and close the cable holder.
1
► 1. Elbow 2. Cable holder 3. Hose band
► 1. Cable holder 2. Control cable
For hip throttle model: Insert the elbow to the flexible
pipe. Tighten the flexible pipe and the elbow with the
hose band.
5. Attach the long/short pipe to the swivel pipe. Turn
the long/short pipe clockwise to lock it into place. Then
attach the blower nozzle with the long/short pipe. Turn
the blower nozzle clockwise to lock it into place.
9 ENGLISH
1
3
2
1
2
2