Assembly Instructions - Makita EB7650TH Manuel D'instructions Original

ASSEMBLY INSTRUCTIONS

ASSEMBLY OF BLOWER PIPES
CAUTION:
Before performing any work on the blower, always stop the engine
●
and pull the spark plug connectors off the spark plug.
Always wear protective gloves!
Start the blower only after having assembled it completely.
●
Always wear protective gloves!
●
1. Insert the swivel (3) into the flexible pipe (1) and tighten them with hose
band (2).
2. Install the control handle / handle assembly (4) onto the swivel and
tighten them with the clamp screw (5).
3. For tube throttle model
Insert the flexible pipe to elbow (6) of the blower.
Attach the cable holder (7) between the hose band (8) and the elbow.
Tighten the cable holder, flexible pipe and elbow with the hose band.
Set the control cable (9) onto the cable holder (7).
For hip throttle model
Insert the flexible pipe to elbow (6) of the blower.
Tighten the flexible pipe and elbow with the hose band (8).
4. Attach the long/short pipe (10) with the swivel. Turn the long/short pipe
clockwise to lock it into place.
Then attach the blower nozzle (11) with the long/short pipe. Turn the
blower nozzle clockwise to lock it into place.
5. Make sure all clamps are tight.
(1)
(6)
(7)
8
(2)
(3)
(4)
(8)
(9)
(11)
(10)
(5)
(7)