Cleaning The Brewing Unit - SEVERIN Piccola Semplice Mode D'emploi

1.
2.
fig. 11: Removing the cover of the brewing unit
The display shows:
Â
rinsing
The filter change is complete as soon as the "Beverage selection"
Â
view is displayed again.
8.3

Cleaning the brewing unit

In addition to an integral cleaning programme, the appliance also offers you
the opportunity to clean the brewing unit manually. For this purpose, the
brewing unit can be removed as follows:
1. Switch the appliance off and disconnect the plug.
2. Remove the water tank and pour out the remaining water.
3. Remove the cover of the brewing unit on the rear of the appliance by
pressing down on the tabs with your thumbs and pulling towards you
(fig. 11).
The brewing unit is now visible.
Â
Version 2 2014-11
1.
2.
fig. 12: Pulling out the brewing unit
4. Pull the red lever of the brewing unit upwards and pull the brewing unit
downwards at an angle out of the machine (fig. 12).
5. Clean the brewing unit under running water.
6. Insert the brewing unit into the machine and push it in until, the locking
latches are aligned. (fig. 13).
7. Press the red lever of the brewing unit down. If the lever does not move,
check the position.
8. Close the brewing unit again with the cover.
1.
2.
fig. 13: Inserting the brewing unit
CAUTION!
Incorrect handling of the brewing unit can cause
damage to the brewing unit.
– Do not take the brewing unit apart or adjust it.
– Push the brewing unit in place from below.
GB
49