Performance Boost Function; Pan Detection - Maytag MIT8795BS Guide D'utilisation

To Turn Off:
Simmer can be turned off in 3 different ways:
1. Use the power slider to set to a heat level.
OR
2. Touch the surface cooking area OFF keypad.
OR
3. Select a different cooking function.
Melt and Hold
The Melt and Hold function can be used with all surface cooking
areas.
To Use
To Turn On:
1. Check that a surface cooking area has been selected.
2. Touch MELT AND HOLD. "A" will appear in the display, and
the indicator light next to Melt will light.
The timer remains visible and can be set if desired.
To Turn Off:
Melt and Hold can be turned off in 3 different ways:
1. Use the power slider to set to a heat level.
OR
2. Touch the surface cooking area OFF keypad.
OR
3. Select a different cooking function.

Pan Detection

If the system cannot recognize the pan, or if the pan has been
removed from the surface cooking area, the "replace pan"
animation appears in the cooking area display as a reminder. See
the following illustration.
If the pan is not placed within 30 seconds, the zone(s) will switch
Off.
If a Timer is running when a pan is removed, the countdown will
continue.

Performance Boost Function

This function allows you to increase the heat setting level above
the maximum heat setting 9 for 10 minutes or less.
NOTES:
Performance Boost function is available on only 1 surface
cooking area at a time within a zone. For example: Within Zone 1,
Performance Boost may be used on surface cooking area A or B,
but not on both. See the following illustration.
A
C
If you attempt to use Performance Boost on more than one
surface cooking area in the same zone, "P" will briefly flash in the
display, and the first surface cooking area selected for
Performance Boost will automatically be set back to the highest
available power setting. The last surface cooking area selected
will be set to Performance Boost.
1. Check that a surface cooking area has been selected.
2. Touch BOOST. "P" will appear in the display.
3. Touch BOOST when finished. The "P" will no longer be visible
in the display, and the Performance Boost function will no
longer be active. The surface cooking area turns back to the
highest available power level.
NOTE: The Performance Boost function may automatically
deactivate to keep the internal electronic components of the
cooktop from becoming too hot.
Timer
Use the cooking timer to set times up to 90 minutes. The timer is
independent of any other control settings. A cooktop element
must be active in order for the cooktop timer to be used.
To Use:
1. Touch the TIMER "up" or "down" pad. "01" appears in the
timer display.
2. Touch the TIMER "up" pad to increase the time in
1-minute increments.
or
Touch the TIMER "down" pad to decrease the time in
1-minute increments.
B
Zone 1
Surface
cooking
areas
A and B
Zone 2
Surface
cooking
areas
C and D
D
7