Overview
Contents
Guarantee, safety instructions
Principal regulations
Contents
Technical data
See technical data Nr 4200 1023 3600
Assembly.......................................... 25
Inspection and adjustment of
MPA22 Control unit, description of
operation, display, programme
structure ...................................... 28-30
Firing ................................................ 32
Commissioning of MPA 22 control
unit
Autotest ............................................ 33
Guarantee
Installation and start-up must be carried
out in accordance with good practice by
a qualified specialist. All applicable
regulations and the instructions that
follow must be complied with. The
manufacturer will decline all
responsibility in the event of failure to
comply fully and in every respect with
any of the relevant requirements. See
also:
- guarantee certificate enclosed with
burner,
- general terms of sale.
Safety
The burner is designed for installation on
a generator connected to correctly
functioning exhaust flues.
It should be used in an area where there
is an adequate supply of combustion air
and where polluted products can be
properly evacuated.
Flue size and design must be
appropriate to the fuel in compliance
with the current regulations and
standards.
The control and safety unit and the cut-
outs used require a power supply of
±1%
+10
230 VAC % 50Hz
with an earthed
- 15
neutral wire.
It must be possible to isolate the burner
from the network by means of a
multipole switch complying with the
current standards.
Maintenance staff should always act
with extreme caution and in particular
avoid direct contact with electrical
circuits and with parts not fitted with heat
insulation.
Avoid splashing water on the electrical
components of the burner.
In the event of flood, fire, fuel leak or
abnormal operation (suspicious smell,
or noise, etc.) switch off the burner, turn
off the power and fuel supplies and call
in a qualified specialist.
It is essential that all furnaces and
accessories, waste gas ducts and
connection pipes are serviced, cleaned
and swept once a year and before
burner start-up. See the applicable
regulations in force.
07/2009 - Art. Nr. 4200 1023 3700A
Principal regulations "FR"
Residential buildings:
- Order of 2 August 1977 and
subsequent amending and
supplementary orders: Technical and
safety rules applicable to gas- and
liquefied hydrocarbon-fired
installations located within residential
buildings and their outbuildings.
- Standard DTU P 45-204: Gas
installations (previously DTU 61-1 -
Gas installations - April 1982 plus
subsequent additions).
- Standard DTU 65.4: Technical
requirements for boiler-rooms.
- Standard NF C15-100 - Low-voltage
electrical installations + Rules.
- Departmental health regulations.
Establishments open to the public:
- Fire safety and panic control
regulations in establishments open to
the public:
General requirements:
- GZ clauses (Gas fuel and liquefied
hydrocarbon installations);
- CH clauses (Heating, ventilation,
refrigeration, air-conditioning and
steam and domestic hot water
production);
Requirements particular to each type of
establishment open to the public.
Outside "FR"
Refer to local regulations.
en
23