C Display Unit Operation; Setting Up The Display Unit; Fitting The Cuff - uebe visomat handy IV Mode D'emploi

Display unit operation
1. Setting up the display unit
Load enclosed batteries, if this has not
already been done (see "Battery ex-
change").
2. Fitting the cuff
Bare your left wrist.
Left-handed users can fit the cuff to their
right arm (observing the general sense of
instructions). With the palm of your left
hand up, put the cuff on your wrist so that
the main body is on the same side as your
palm. Adjust the cuff, with your palm up,
until its edge is positioned 5 to 10 mm
(1/4 to 1/2 in.) from the lowest part of
your palm. Fasten the cuff around your
wrist so that there is no space between
the cuff and your wrist. The cuff should fit
snugly. The cuff sensor underside should
now lie directly on your pulse. Press the
surface of the cuff to make sure that it is
attached securely. With its improved shape
the cuff fits tightly to prevent measure-
ment failures.
C
GB-37