Assembly - Prophete 2026 Notice D'utilisation

ASSEMBLY

• The handlebars and seat post may only be pulled out to the maximum
mark! The marking of the minimum insertion depth should not be seen!
Danger of damage and accident! - If disregarded, no warranty!
DANGER
WARNING
1. Loosen the cap nut
order to move the drop out protection
2. Place the wheel in the frame and hook the drop out
protection
1
3. Mount the other wheel into the fork as previously de-
scribed.
4. Tighten all wheel nuts
specification (see Torque specification chapter).
5. Place a bearing bushing
guiding it from below through the frame
fork with the second bearing bushing
frame can be used the other way around for taller
children. This gives the child a higher seat position.
6. Loosen the screw connection of the clamp
place it on the fork (Fig. D).
7. Push the cover of the screw connection
handlebars
1
the clamping screw
cation. Then push the cover
(Fig. D).
8. Release the screw connection of the frame clamp
Push the cover of the screw connection
seat post , guide it into the frame and tighten the
2
frame clamp
Then push the cover
BDA_2026_2048_DE_GB_F_I_NL_PL_HU_RO.indd 27
on both sides of the wheel in
2
into the designated hole (Fig. B).
according to the torque
2
on the fork
1
, guide it into the fork tube and tighten
according to the torque specifi-
3
over the screw fitting
2
according to the torque specification.
3
over the screw fitting (Fig. E).
1
B
.
1
C
first before
2
. Fix the
3
(Fig. C). The
1
and
3
D
over the
2
.
3
over the
1
E
Assembly
1
2
1
2
3
1
1
2
3
1
2
3
27
17.03.2015 10:09:40