Preparing An Espresso Coffee (Ded/Dedpid); Programming The Coffee Doses; Pre-Infusion - La Pavoni DOMUS BAR Mode D'emploi

e. Press the coffee in the filter holder against the Coffee press (12).
f. Insert the filter holder (8) in the coffee group (5) and turn it from left to right with force.
g. Attention: before switching on the coffee/ hot water lever (14), make sure that the steam lever (15) is on
the "0" position.
h. Push the coffee/ hot water lever (14) on the position "I". Once reached the required coffee quantity, push
the coffee/ hot water lever (14) on the position "O". It stops supplying coffee.
i. Remove the filter holder (8) and throw away the coffee grounds.
N.B we advice never to let the coffee come out for more than 40 seconds
11.3.1 PREPARING AN ESPRESSO COFFEE WITH THE MACHINE (DOMUS BAR ELETTRONICA DOSATA - DOMUS
BAR TERMOPID DOSATA)
When the machine is on the stand-by mode and it's not working, you'll see the led of the front panel go on in a
sequential way.
Make sure to follow the instructions as per 11.1 "Starting of the machine".
As soon as the PID's display shows the set temperature and the indicator light (15a) remains on, the machine is
ready for use.

11.3.1.1 PROGRAMMING THE COFFEE DOSES

With this machine it's possible to program two different coffee doses of water in order to obtain one or two cups
of coffee. In order to set the water doses and memorize them for future use, follow the present instructions:
a. Insert the one cup filter (9) or two cup filter (10) in the filter holder (8).
b. Press with the filter holder (8) the grinding switch (17) to start grinding. Once you have ground enough
coffee, remove the filter holder from the switch (17).
c. Press well the coffee in the filter holder with the use of the coffee presser (12).
d. Place the filter holder (8) under the brewing group (5) turning it from the left to the right with strength.
After these operations please act as follows:
1. Press the programming switch (22) for 5 seconds till the led (6) will start to blink. The symbol of the switches
23 and 24 will go on at the same time.
2. Once you have placed the one cup filter, press the switch (23) and let the coffee come out.
3. Press again the same switch (23) once you get the desired coffee quantity.
4. The water dose programmed for one coffee will be memorized on the switch (23) and the relative led will
go off.
5. Repeat the operations described under point 3 & 4 in order to program the water dose for the switch (24).
6. Each customer is free to program the water doses of the switches (23) and (24) in order to obtain a stronger
or smoother coffee using the one or two cups filter.
7. After the doses have been memorized, press again the switch (22) "MENU" in order to end programming.
8. The switches led will start to go on again in a sequential way. The machine will then be ready for dispensing
excellent coffees.

11.3.1.2 PRE-INFUSION

The machine gives the possibility of programming the doses so that there is a pre-infusion. Pressing the switches
(23) and (24), the normal dispensing cycle comes after a short water jet that makes the coffee wet before the
water definitively flows through it. In this way there is a better extraction of the coffee from the coffee dose.
N.B The machine is programmed to have this pre-infusion function. Should you want to deactivate it, please follow
the instructions below:
ACTIVATION OF THE PRE-INFUSION
When the machine is off, turn it on by pressing the switch (24). The led will go on and this indicates that the
pre-infusion function has been activated. Then turn it off and straight way on again.
27
English